First I cannot output a DOCTYPE declaration for an html document even if I put it in CDATA. The brackets get converted to their entities
Also, how can I output a new line character in XSLT? I tried &10;&13; but it won't accept it. If you put it in CDATA, it converts &'s into &'s
Hi
First of all, to write out a non/breaking space in XSL/T, you must not attempt to use character codes, they wont work. You will need to use the following entities (these should work ok):-
  = non breaking space ( in html)
= new line
are you declaring the doctype inside square brackets [] ?
You havnt put any of your code here, so it makes it difficult to diagnose
hth
Scott
it keeps rendering the code - i will try again
non breaking = & # x a 0 ;
breaking = & # 10 ;
there are no gaps in the entities, i had to split them to show them in this post